+86-371-64966831
E-mail: yifanseo@yfmac.com
Cone crusher in a spherical bearing on the Sand Maker product line, water or freezing liquid ring groove in the cone drive body 3 , welded cut tapered dust ring , the lower end of the insert groove verifying the water , put the dust of the dust ring block, it fell into the sink , so , you can prevent dust from entering inside the crusher . The dust accumulated in the water seal device , use the recycled water continuously washed away, To this end , the outlet at the sink , install a drain to take over the intake , install a water take over .Recycled water from the dedicated tank with a pump through the pipe into the sink , round water tank return flow along the pipe from the drain .
The cone crusher of a water seal to maintain the Sand Maker product line, mainly due to the following aspects ; filled with water seal with the water should be clean , and contained little sediment into the water seal water should be adequate . Do not make the water overflow from the edge of the water seal of not less than the required flow .
There is no water in the water seal does not work, because this time the dust will enter the production line in the sand inside the cone crusher , the oil discharge groove blockage , while the oil will inevitably have to be dirty , causing spherical bearings and other vital parts had early wear and tear.
Replace the dust-proof rubber ring 6 must be dust-proof rubber ring between the edge of the dust ring on the 6 and the conical drive body to retain a gap of about 2 to 3 mm . The need to prevent the water seal to freeze the accident , because of the demolition and clean - up water seal will make the crusher long-stay parking , impact on production .
Thank you for your interest in YiFan. Please use any of the methods below to get in touch with us.
Add: The Middle of Zhengyuan Road, Xingyang Eastern Development Zone.
zip:450100
E-mail:yifanseo@yfmac.com
MSN On line: yifancrusher@yahoo.cn
ICQ: 639607958 QQ: 2502761202
Tel: +86-371-64628852 Fax: +86-371-64628872
The article by Sand Maker product line,sand plants,Sand Maker plant Yifan Machinery Editor: http://www.sandplant.net/ , please indicate the source , little effort , thank you .